Page 1 of 1

Where are the conflict rules?

PostPosted: Wed Oct 26, 2011 4:32 pm
by eliaslynch
I see audits are imported into navigator from discovery like in an6, but what controls the conflict resolution? an6 had rules you could configure to control that.

Re: Where are the conflict rules?

PostPosted: Fri Oct 28, 2011 10:43 am
by pille
The conflict rules in express are hard coded. It uses the ID for Discovery so after the first time a computer audits it should automatically overwrite going forward, and or create a new item if it doesn't match.

I think there will be a couple things changed with this for release as there's a couple kinks to work around with the PO receiving <> audit flow.

Re: Where are the conflict rules?

PostPosted: Tue Nov 01, 2011 11:57 am
by eliaslynch
pille wrote:I think there will be a couple things changed with this for release as there's a couple kinks to work around with the PO receiving <> audit flow.


Good cause I can see that being a bit of a problem in some cases.