Where are the conflict rules?

Open discussion about the Alloy Navigator Express 6 application

Where are the conflict rules?

Postby eliaslynch on Wed Oct 26, 2011 4:32 pm

I see audits are imported into navigator from discovery like in an6, but what controls the conflict resolution? an6 had rules you could configure to control that.
--------
Elias
User avatar
eliaslynch
Senior
 
Posts: 212
Joined: Wed Jul 09, 2008 7:03 pm

Re: Where are the conflict rules?

Postby pille on Fri Oct 28, 2011 10:43 am

The conflict rules in express are hard coded. It uses the ID for Discovery so after the first time a computer audits it should automatically overwrite going forward, and or create a new item if it doesn't match.

I think there will be a couple things changed with this for release as there's a couple kinks to work around with the PO receiving <> audit flow.
Contact Technical Services directly:
support@alloy-software.com
http://support.alloy-software.com

Paul Ille
Alloy Software
Maximize your IT Universe
Follow us on Twitter: http://twitter.com/alloysoftware
Image
User avatar
pille
Alloy Software
 
Posts: 473
Joined: Thu Aug 11, 2005 3:11 pm
Location: New Jersey, USA

Re: Where are the conflict rules?

Postby eliaslynch on Tue Nov 01, 2011 11:57 am

pille wrote:I think there will be a couple things changed with this for release as there's a couple kinks to work around with the PO receiving <> audit flow.


Good cause I can see that being a bit of a problem in some cases.
--------
Elias
User avatar
eliaslynch
Senior
 
Posts: 212
Joined: Wed Jul 09, 2008 7:03 pm


Return to Alloy Navigator Express 6 Discussion

Who is online

Users browsing this forum: No registered users and 1 guest