Page 1 of 1

Networks do not update Computers and IPs

PostPosted: Wed Sep 02, 2009 5:35 pm
by Dan Stuckey
I apologies if the answer is obvious, I am a new user.

I configured two of my company networks and it did not make any difference to my computers. I expected they associate with my new networks based on IPs... I'm referring to the Network field for computers, IP Address under Network... Did I miss anything in my config?

Re: Networks do not update Computers and IPs

PostPosted: Fri Sep 04, 2009 12:42 pm
by Tom Rainolds
You should configure networks first and then upload computers from audit results. According to Alloy support it would work vice versa.