Page 1 of 1

Stream Read error

PostPosted: Mon Nov 27, 2006 11:17 pm
by RabidDawg
can't find any solution on this. I'm getting a stream read error while running the adt2xml utility. I've ran the Network Inventory about 4 times to make sure I didn't have a corrupted file and rebooted the computer.

Thanks,

Brian

PostPosted: Tue Nov 28, 2006 10:12 am
by RabidDawg
ok. After much frustration I tracked it down to one audit file, if I try to open that audit file the quickviewer says it is corrupted, however when running the Network Inventory it never said it was corrupted. Suggestions?