Page 1 of 1

Auditing a Dell M1000e Blade Array

PostPosted: Mon Dec 13, 2010 10:06 am
by Tristan
We've recently purchased a Dell M1000e blade array with 6 blades

The blade enclosure has a serial number as well as each of the blades. When we audit the blades they are reporting the serial number of the chassis are their own serial number. Therefore when we load them into Asset Navigator they all conflict with each other.

Has anyone encountered such an issue before?

Does anyone know the mechanism Discovery uses to extract the Serial number so that we can pin-point what's going wrong?


Thanks,

Re: Auditing a Dell M1000e Blade Array

PostPosted: Thu Dec 16, 2010 6:24 pm
by eliaslynch
what version of Alloy Navigator are you using with Discovery?