Page 1 of 1

Error: "Could Not intialize Crystal Report Connector"

PostPosted: Thu Jun 18, 2009 1:49 pm
by jchan
Hi, could someone help me on this one? :wink:

When I attempt to design a report by clicking on the "Design Report" button on the menu of the Report List, I get this error message: " Could not intialize Crystal Report Connector".

1. Do you know what is causing the error? :(
2. How do I solve this?

Thank you very much for helping.

Re: Error: "Could Not intialize Crystal Report Connector"

PostPosted: Mon Jun 22, 2009 4:26 pm
by janstonselig
jchan wrote:When I attempt to design a report by clicking on the "Design Report" button on the menu of the Report List, I get this error message: " Could not intialize Crystal Report Connector".


I found this article in Alloy's kb that should fit your issue, but you said the error says 'connector' so I dunno. This article matches except for that word.

http://support.alloy-software.com/?mode ... d=KB001096